Additional Information; Troubleshooting - Sony SLV-SE700G Operating Instructions Manual

Additional Information

Troubleshooting

If you have any questions or problems not covered below, please consult your nearest Sony
service facility.
Symptom
The ?/1 ON/STANDBY
switch does not function.
The power is turned on but
the VCR does not operate.
The VCR is plugged in but
the display window remains
dark.
The clock has stopped and
"–:– –" appears in the
display window.
The playback picture does
not appear on the TV
screen.
The picture is not clear.
The picture rolls vertically
during picture search.
The picture has no sound.
The sound is unstable or has
an echo.
Remedy
• Connect the mains lead to the mains securely.
• Moisture condensation has occurred. Turn the power off, unplug
the mains lead and leave the VCR to dry for over three hours.
• Set POWER SAVE in the OPTIONS-2 menu to OFF (see page
73).
• The clock stops if the VCR is disconnected from the mains for
more than one hour. Reset the clock (and timer).
• Make sure the TV is set to the video channel. If you are using a
monitor, set it to video input.
• If the VCR is connected to the TV with the Scart cable, make sure
the VIDEO indicator is lit in the display window. Use the t TV/
VIDEO button on the remote commander to light up the VIDEO
indicator.
• If your TV is connected to the VCR with both Scart and aerial
cables, make sure the RF channel is set to OFF (see page 16).
• Existing broadcasts may interfere with the VCR. Reset the RF
channel output of your VCR.
• Adjust the tracking with the TRACKING +/– buttons.
• The video heads are dirty (see the last page of Troubleshooting).
Clean the video heads using the Sony T-25CLD, E-25CLDR, or T-
25CLW video head cleaning cassette. If these cleaning cassettes
are not available in your area, have the heads cleaned at your
nearest Sony service facility (a standard service charge will be
required). Do not use a commercially available liquid type
cleaning cassette other than Sony's, as it may damage the video
heads.
• The video heads may have to be replaced. Consult your local Sony
service facility for more information.
• Adjust the vertical hold control on the TV or monitor.
• The tape is defective.
• If you made A/V connections, check the audio cable connection.
• When you play a tape with the same sound recorded on both the
hi-fi and normal audio tracks, make sure AUDIO MIX in the
OPTIONS-1 menu is set to OFF.
continued
Troubleshooting
79