Sony SLV-SE610K Operating Instructions Manual page 13

To
Adjust the volume of the TV
Switch to TV (Teletext off)*
Switch to Teletext*
Select the sound
Use FASTEXT*
Call up the on-screen display
Change the Teletext page*
Switch to/from wide mode of a Sony wide TV (For
other manufactures' wide TVs, see "Controlling
other TVs with the remote commander (SLV-
SE810N/K only)" below.)
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.
* SLV-SE810N/K only
Controlling other TVs with the remote commander
(SLV-SE810N/K only)
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the following table, set the appropriate manufacturer's code
number.
Set [TV] / [VIDEO] at the top of the remote commander to [TV].
1
Hold down ?/1, and enter your TV's code number using the programme
2
number buttons. Then release ?/1.
Now you can use the following TV control buttons to control your TV:
?/1, t TV/VIDEO, programme number buttons, - (ten's digit),
PROG +/–, 2 +/–, a (TV), / (Teletext), FASTEXT buttons, WIDE*,
M m <
MENU*, / /
* These buttons may not work with all TVs.
,
/ *, and OK*.
Press
2 +/–
a (TV)
/ (Teletext)
AUDIO MONITOR
FASTEXT buttons
DISPLAY
c/C
WIDE
continued
Setting up the remote commander
13