Cleaning And Care; Troubleshooting - HoMedics CELL-200 Instruction Manual And Warranty Information

C L E A N I N G A N D C A R E
CAUTION: before cleaning the unit, turn power off and unplug, allowing the unit to cool before
cleaning.
T O C L E A N T H E S U R F A C E
Clean the surface of the unit with a clean, damp, soft cloth.
NOTE: Never allow water or any other liquids to come in
contact with the unit.
• Do not immerse in any liquid to clean
• Never use abrasive cleaners to clean the unit.
T O S T O R E
Place components into its box and store in a safe, dry place.
DO NOT wrap the power cord around the unit. DO NOT hang
the unit by the cord.
8 8
T R O U B L E S H O O T I N G
PROBLEM POSSIBLE CAUSE
• Unit is not plugged in
Unit will not operate
• No power to unit
F C C S T A T E M E N T
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This class B digital device complies with Canadian ICES-003.
SOLUTION
• Plug unit in
• Press the ON/OFF button to turn
the power on
• Check circuits, fuses, try a different
outlet.
9 9