Advertisement
Figure 1
Medical Precautions
HOSE
This unit should not be used in the following cases:
•
Tuberculosis, benign and malignant tumors, hemorrhages,
CONTROL UNIT
MAT
inflammations of the skin, phlebitis and thrombosis, open
and fresh wounds, bruises, broken skin or varicose veins, or
undetermined calf pain.
• If you intend to use your BubbleSpa for therapeutic
purposes, consult your physician first.
• Do not use on any part of the body that is anesthetized.
Figure 2
• Do not use on any part of the body where surgery has
been performed.
Connector
Mat
• Do not use on any unexplained pain before consulting your
doctor.
• If you have any concerns regarding your health, consult your
doctor before using this product.
Mat
Suction
Bathtub Floor
BubbleSpa Massaging Bubble Mat Features
Cups
• Comfortable air-filled bubble mat contours to any bath
Figure 3
surface.
• Variable control to customize relief from gentle bubbles to
powerful jet streams
LOCK
UNLOCK
• Lightweight and compact for easy storage and portability
UNLOCK
LOCK
Installation Instructions
Raised
Bead
1. Remove the mat from its packaging and make sure all
necessary components are included: mat, hose suction cup,
control unit and hose (Fig. 1).
Figure 4
2. Be sure the control unit is unplugged and positioned on a
SUCTION
sturdy surface where it cannot fall or be pulled into the tub,
CUP
preferably the floor.
4
3. To place the mat, first dampen tub surface with a slight
amount of water. This will help the adhesion of suction
Figure 5
cups (on bottom of mat) to bathtub floor (Fig. 2).
Attach as
4. To connect the hose to the control unit, line up the arrow
close to
on the hose with the unlock mark on the control unit.
rim as
possible
Insert the hose end (with raised bead) into the control unit
and turn counter clockwise to the lock position (Fig. 3).
The raised bead should be lined up with channel when
inserted.
5. Insert the other end of the hose into the mat (Fig. 4).
6. Attach the hose to the side of the bathtub with the suction
cup which is attached to the hose (Fig.5). The suction
Figure 6
cup will help to stabilize the hose and should be attached
along the upper edge of the bathtub.
7. Plug unit into 120 volt electrical outlet.
Instructions For Use
1. Set the speed control to the desired setting (Fig. 6).
2. After use, turn the control unit off. Drain the tub.
3. To remove any remaining water inside the mat, lift mat,
Caution:
keeping the hose attached and hold at an angle
so water collects in the corner (Fig. 7). Turn unit on and
Mat may move
blow air through the mat for 30-45 seconds. Towel dry
when entering or
outside of mat.
exiting bathtub.
4. After mat is completely dry you can roll for storage.
Exercise caution.
5
Advertisement
