Sony SLV-SE240G/I Operating Instructions Manual page 14

To
Switch to Teletext*
Select the sound*
Use FASTEXT*
Call up the on-screen display
Change the Teletext page*
Switch to/from wide mode of a Sony wide TV (For
other manufactures' wide TVs, see "Controlling
other TVs with the remote commander (SLV-
SE840G only)" below.)
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types of batteries together.
• Do not leave the remote commander in an extremely hot or humid place.
• Do not drop any foreign object into the remote casing, particularly when replacing
the batteries.
• Do not expose the remote sensor to direct light from the sun or lighting apparatus.
Doing so may cause a malfunction.
• Some buttons may not work with certain Sony TVs.
1
* SLV-SE840G only
2
* not available on SLV-SE240G/I
Controlling other TVs with the remote commander (SLV-
SE840G only)
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the following table, set the appropriate manufacturer's code
number.
1 Set [TV] / [VIDEO] at the top of the remote commander to [TV].
2
Hold down ?/1, and enter your TV's code number using the programme
number buttons. Then release ?/1.
Now you can use the following TV control buttons to control your TV:
?/1, t TV/VIDEO, programme number buttons, - (ten's digit),
PROG +/–, 2 +/–, a (TV), / (Teletext), FASTEXT buttons,
* These buttons may not work with all TVs.
14
Setting up the remote commander
1
2
1
1
(wide)*, MENU*,
M
/ / / *, and OK*.
m < ,
Press
/ (Teletext)
AUDIO MONITOR
FASTEXT buttons
DISPLAY
c / C
(wide)