Ntp-Service Broadcast-Client - H3C S5500-EI Series Command Manual

Command Manual – NTP
H3C S5500-EI Series Ethernet Switches
Caution:
Presently the system supports only the MD5 algorithm for key authentication.
You can set a maximum of 1,024 keys for each device.
If an NTP authentication key is specified as a trusted key, the key automatically
changes to not trusted after you delete the key. In this case, you do not need to
execute the undo ntp-service reliable authentication-keyid command.
Examples
# Set an MD5 authentication key, with the key ID of 10 and key value of BetterKey.
<Sysname> system-view
[Sysname]
BetterKey

1.1.7 ntp-service broadcast-client

Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
View
VLAN interface view
Parameters
None
Description
Use the ntp-service broadcast-client command to configure the device to work in the
NTP broadcast client mode.
Use the undo ntp-service broadcast-client command to remove the device as an
NTP broadcast client.
Examples
# Configure the device to work in the broadcast client mode and receive NTP broadcast
messages on VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-client
ntp-service authentication-keyid
Chapter 1 NTP Configuration Commands
10
1-8
authentication-mode md5