Sony SLV-ED10ME Operating Instructions Manual page 8

Step 4: Tuning your TV to the VCR (continued)
5
6
RF CHANNEL
To obtain a clear picture from the VCR
If the picture does not appear clearly in step 5 above, go to step 6 to finish
this procedure once. Then start from step 2. After pressing RF CHANNEL in
step 2 to display the RF channel, press PROGRAM +/– so that another RF
channel appears. Then tune the TV to the new RF channel until a clear
picture appears.
If you cannot obtain a clear picture after performing this procedure, we
recommend you connect the VCR and TV using an audio/video cable (see
"To a TV that has audio/video input jacks" on page 6). If the same symptom
persists, consult your nearest Sony dealer.
Note
• If you set the wrong TV system, you may have no sound or sound may be distorted
(noisy sound).
8
Getting Started
Tune the TV to the same channel as that
shown in the display window so that
the picture on the right appears on the
TV screen.
Refer to your TV manual for tuning
instructions.
If the picture does not appear clearly,
see "To obtain a clear picture from the
VCR" below.
Press RF CHANNEL.
You have now tuned your TV to the VCR. From now on, whenever
you want to play a tape, set the TV to the video channel.
SONY VIDEO CASSETTE
RECORDER