Table of Contents
Advertisement
Notes
• If you use a satellite tuner
connected via the EURO
LINE (Scart) connector, you
don't have to set up VIDEO
Plus+. Just record a satellite
programme using VIDEO
Plus+, and the unit's VCR
automatically records the
programme from the EURO
LINE IN connector.
• When you record a satellite
broadcast using VIDEO
Plus+, you need to select the
desired channel on the
satellite tuner manually.
Setting up VIDEO Plus+ for satellite broadcasts
If your satellite tuner is connected via the AERIAL IN connector, you
must first set the programme position for each satellite channel using
the TUNER PRESET menu. Then, set the guide channel number for
each satellite channel using the SET UP CH & VIDEO Plus+ menu.
If your satellite tuner is connected via the LINE jacks, you don't have to
set programme positions and guide channel numbers for satellite
channels, and can skip the following operations.
1 Turn on the satellite tuner.
2 Press MENU. Then select VHS MENU, and press EXECUTE.
3 Select TUNER PRESET and press EXECUTE.
4 Press PROG +/– to select a programme position you want to use for
watching a satellite channel.
5 Select CHANNEL SET, then press CURSOR / to tune the unit's
VCR to the satellite tuner.
The channel number displayed beside CHANNEL SET is used for
receiving all satellite broadcasts from the satellite tuner.
TUNER PRESET
PROG6
CHANNEL SET
3
0
AFT
ON
OFF
FINE TUNING
SELECT
:
SET
:
6 Press PROG +/– to select another programme position for another
satellite channel, and press the programme number buttons to enter
the same channel number as the one displayed in step 5.
Repeat this step for all satellite channels.
7 Set the guide channel number for each programme position assigned
to the satellite channel, following the procedures in "Manual setup –
Selecting station names/setting up VIDEO Plus+" on page 22.
Getting Started
25
Advertisement
Table of Contents
