Basic Operations; Creating Clip Lists - Sony PDW-1500 Operation Manual

5-2 Basic Operations

5-2-1 Creating Clip Lists

You can create a clip list by either of the following two
methods.
• Selecting a desired clip from the thumbnail display, and
including it in the clip list as a sub clip.
• Creating any sub clip from a full-screen display clip, and
including it in the clip list.
Note
Up to 99 clip lists can be handled in the CLIP menu.
Including a clip selected from the
thumbnail display in the clip list
To select the desired clip from the clip thumbnail display
and include it in the clip list, proceed as follows.
SG DATA SG DATA SG DATA SG DATA
ACCESS
ANA SDI ANA SDI ANA SDI ANA SDI
AE8/EBU AE8/EBU AE8/EBU AE8/EBU
dB OVER dB OVER dB OVER dB
0 0 0 0
NETWORK -12 -12 -12 -12
LOCAL -20 -20 -20 -20
REMOTE
-30 -30 -30 -30
-40 -40 -40 -40
MONITOR
-60 -60 -60 -60
15 26 37
CH- CH- CH- CH-
L
MIX
R AUDIO
MONITOR SEL METER SEL INPUT CH INPUT SEL
ALL/CH-1 CH-2
VARIABLE
REC
PRESET
PB
PHONES
PREV PLAY NEXT
TOP F REV F FWD
SUBCLIP button
1
With the SUBCLIP button off, press the
THUMBNAIL button, turning it on.
The thumbnails of the clips on the disc appear.
62
5-2 Basic Operations
RESET button
4 3
EJECT
EDIT REMOTE [9P iLINK] KEY INH
ALARM
INPUT
VITC VIUB COUNTER VITC REC INH
i.LINK
OVER
SDI
CMPST
Y-R,B
SG
HOURS MINUTES SECONDS FRAMES
MONITOR
1/2 3/4 AUDIO 625 IMX[50 40 30]
48 5/6 7/8 4 8 CH 18 24 BIT 525 DVCAM
VIDEO COUNTER SYS MENU SHIFT
INPUT SEL SELECT HOLD MENU
CH-3 CH-4 SUB THUMB
CLIP NAIL SET RESET
CLIP ESSENCE S.SEL
MENU MARK MARK1
STOP REC
IN OUT
END
MARK2
1 2
2
Use the arrow buttons or the jog dial to select the clip
you want to include in the clip list.
You can select clips with the following operations.
Press the PREV or NEXT button: Move to the
previous or next clip.
Press the PREV or NEXT button with the SHIFT
button held down: Move to the first or last clip.
Press the F or f button with the SHIFT button held
down: Switch to the previous or next page.
3
Hold down the SHIFT button, and press the SET
button.
The scene selection window appears.
To escape from the scene selection window to the
previous screen
Press the RESET button.
4
Press the SET button.
This adds the selected clip to the clip list as a sub clip.
At the same time, this closes the scene selection
window and returns to the original thumbnail display.
5
Repeat steps 2 to 4 until all desired clips have been
added to the clip list.
The scene selection window shows the thumbnails of
the sub clips that have already been included in the clip
list. The cursor within the window indicates the
position in which the next sub clip will be included.