Getting Started; Installing The Batteries; When To Replace The Batteries - Sony RM-VL700 Operating Instructions (primary manual) Operating Instructions Manual

Integrated remote commander
Hide thumbs Also See for RM-VL700 Operating Instructions (primary manual):
Table of Contents

Advertisement

Getting Started

Installing the
Batteries
Slide open the battery
compartment lid and insert two
size AA(R6) batteries (not
supplied). Be sure to match up the
+ and – indications on the
batteries with the + and –
indications on the battery
compartment.
Insert the batteries negative-and-
first through the guide clamp
within each compartment as
shown above.
6
When to replace the
batteries
Batteries for remote control
operation (two size AA (R6)
batteries)
Under normal conditions, the
batteries will last up to six
months. If the Commander does
not operate properly, the batteries
might be drained. When this
happens, replace the batteries with
new ones.
Note
Do not take more than one hour to
replace the batteries. Otherwise, your
setting of the code numbers (page 8)
and "learned" remote control signals
(page 15) will be erased.
Notes on batteries
• Do not use an old battery with a new
one or mix different types of batteries
together.
• If the electrolyte inside the battery
should leak, wipe the contaminated
area of the battery compartment with
a cloth and replace the old batteries
with new ones. To prevent the
electrolyte from leaking, remove the
batteries when you plan not to use
the Commander for a long period of
time.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rm-vl700s

Table of Contents