Notes On Learning The Signals Of An Air-Conditioner - Sony RM-VL1000 Operating Instructions Manual

Using Non-Preset Remote
Control Operations
— Learning Function (continued)
If you make a mistake, move
the cursor to the digit or
character you want to correct
by pressing the
and input again.
4
Decide the digit or the
character you input by
pressing the Joystick
toward .
The cursor moves to the right.
When the Joystick is pressed
toward , the cursor moves to
the left. You can input a digit or
character to the place where
the cursor flashes.
5
Repeat Steps 3 and 4 until
you input a suitable name
to the label.
When the cursor reaches to the
right end, if the Joystick is
pressed toward , the cursor
returns back to the left end.
6
Press the SET button.
The commander enters the
learning standby mode.
28
or button,
Notes on learning the
signals of an air-
conditioner
About seasonal adjustments
If you change the settings of the
air-conditioner for the season, you
have to program the remote
control signals of the new settings
on the Commander.
If the power-on/off operation
does not work correctly
The air-conditioner may not be
turned on or off properly with the
button or key of this Commander,
for which you have programmed
its power-on/off signal.
If the Commander can operate
only "ON" with one button or
label and "OFF" with another,
while your air-conditioner's
remote control can operate "ON/
OFF" with a single button or label,
program the signal on two buttons
or labels of the Commander as
follows.
1 Clear the learned power-on/off
signal from the button or label
(page 29).
2 Program the signal (transmitted
from the power-on/off button
of the air-conditioner's remote
control) for the button or label
again.
3 Program the signal from the
same button of the remote
control for another button or
label.
The two buttons or labels of the
Commander have been
programmed with the power-on
signal and the power-off signal of
the air-conditioner, respectively so
that you can operate the air-
conditioner with the Commander.