Receiving The Data - Sony RM-AV2100B Operating Instructions (primary manual) Operating Instructions Manual

7
Press the "ENTER" key.
When the data has been transferred,
"TV" and "M" go off. If the data have
been successfully transferred, the
backlight of the display turns off.
Note
If "NG" appears while sending the data, go
back to Step 6 and continue the operation
or press COMMANDER OFF to stop the
operation.
Notes
• The data of the "learned" signal and the
System Control function programmed for a
Component Select button cannot be
transferred.
You can use the learning function (page 32) to
program the "learned" signal and the System
Control functions programmed for a
Component Select button on another remote
commander.
• Be sure that the receiving remote commander
is ready to receive data.

Receiving the data

This Commander can receive the data of
another Sony RM-AV2100 or RM-VL900.
To receive the all data from
another remote commander
1
While pressing COMMANDER
OFF, press CHANNEL – and
VOLUME –.
Continued
43