Connecting To The Gsm Alarm Module - Siemens SENTRON 5TT7 System Manual

2.3

Connecting to the GSM alarm module

Preferably connect the GSM alarm module to a 24 V DC power supply and then connect the
module to the USB interface of a PC using a USB cable. Wait until the module has started
up and then start the configuration software.
Note
It takes the module roughly 90 seconds to start up completely. After the operating voltage
has been connected, the first LED lights up after about 10 seconds.
When the software is started, it searches through all COM interfaces of the PC for a
connected GSM alarm module. If a module is found, the software downloads the module's
data and asks whether you wish to load the module's settings in the configuration software.
● Yes: all set values are displayed in the configuration software and can be edited.
● No: the configuration software's fields are not filled.
Note
The "Upload settings to module" function overwrites all values in the module with the
ones specified in the configuration software. Empty fields are also transferred to the
module.
If no module is found during starting, although a module is connected, click on the "Connect"
button on the top right of the window
or select "Connect to module" on the "Synchronize" tab.
The text 'Connected' appears in the bottom left corner if the module has been found.
GSM alarm module
System Manual, 06/2014, 2541304131-01
2.3 Connecting to the GSM alarm module
Module
13