Changing The Programmed Commands - Sony RM-AV2000 Operating Instructions (primary manual) Operating Instructions Manual

Changing the programmed
commands
To clear programmed commands
1
While pressing COMMANDER
OFF, press one of the SYSTEM
CONTROL 1, 2, or 3 button.
COMMANDER SYSTEM CONTROL
+
OFF
The key operations programmed for
that button are displayed in order.
2
While pressing the RESET key,
press the same SYSTEM
CONTROL button (1, 2, or 3)
again.
RESET
+
SYSTEM CONTROL
The contents of its program are
cleared and all the component names
flash.
RESET
LEARN TV VCR
AMP
SC1
When you want to set a new program
to this SYSTEM CONTROL button,
follow the Steps 2 – 5 on Page 21.
1
1
DVD DBS TUNER
123
MD DECK CBL CD OP
AB
To set SYSTEM CONTROL 3 back
to the factory setting (Power-on
commands for Sony
components)
1
While pressing COMMANDER
OFF, press SYSTEM CONTROL 3.
COMMANDER SYSTEM CONTROL
+
OFF
The programmed key operations are
displayed in order.
2
While pressing the RESET key,
press SYSTEM CONTROL 3.
RESET
+
SYSTEM CONTROL
The contents of its program are
cleared and all the components names
flash.
3
While pressing the RESET key
again, press SYSTEM CONTROL
3 again.
RESET
+
SYSTEM CONTROL
The series of the Power-on commands
for Sony Components are set and the
programmed operations are displayed
in order.
3
3
3
23