Changing The Factory Setting Of A Function Button - Sony STR-DA1ES Operating Instructions Manual

Remote button description
(continued)
Remote Operations
Button
POSITION**TV
SWAP** TV
SUB CH TV
+/–**
P IN P** TV
JUMP TV
WIDE TV
TV/VIDEO TV
** Only for Sony TVs with the picture-in-picture
function.
Notes
• When you press the function buttons (VIDEO 1,
VIDEO 2, VIDEO 3, DVD/LD), the input mode of
the TV might not switch to the corresponding input
mode that you want. In this case, press the TV/
VIDEO button to switch the input mode of the TV.
• Some functions explained in this section may not
work depending on the model of the receiver.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• The TV/SAT and PHONO functions are not
available for set operation.
Changing the factory
setting of a function button
If the factory settings of the FUNCTION
buttons do not match your system components,
you can change them. For example, if you have
an MD player and a tape deck and you don't
have a CD player, you can assign the CD/SACD
button to your tape deck.
GB
56
Function
Changes the position of
the small picture.
Swaps the small and the
large picture.
Selects the preset
channels for the small
picture.
Activates the picture-in-
picture function.
Toggles between the
previous and the current
channels.
Selects the wide picture
mode.
Selects input signal: TV
input or video input.
Note that the settings of the TUNER and
FN SHIFT functions (VIDEO 1, VIDEO 2,
VIDEO 3, PHONO and MD/TAPE) button
cannot be changed.
1
Hold down the Function button whose
function you want to change (for
example, CD/SACD).
2
Press the corresponding button of the
component you want to assign to the
Function button (for example, 4 – Tape
deck).
The following buttons are assigned to select
the functions:
To operate
CD player
DAT deck
MD deck
Tape deck A
Tape deck B
LD player
VCR (command mode VTR 1*)
VCR (command mode VTR 2*)
VCR (command mode VTR 3*)
TV
DSS (Digital Satellite Receiver)
DVD
VCD player
* Sony VCRs are operated with a VTR 1, 2 or 3
setting. These correspond to Beta, 8mm and
VHS respectively.
Now you can use the CD/SACD button to
control the tape deck.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the function buttons to
their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
Press
1
2
3
4
5
6
7
8
9
0
>10
ENTER
.