Advanced Remote Operations; Operating One Component While Using Another (Background Operation); Changing The Factory Setting Of A Function Button - Sony STR-GA7ES Operating Instructions Manual

Advanced Remote Operations

Operating One Component
While Using Another
(background operation)
You can temporality operate other components while
listening to or watching a program.
Numeric
buttons
BACKGROUND
0 )
1
Hold down BACKGROUND.
2
Press both the corresponding numeric button of
the component you're going to use (see the table
below) and one of the following buttons at the
same time; VISUAL POWER, TV/VIDEO, CH
PRESET +/–, ANT TV/VTR, D.SKIP, (, 9, p,
0/), =/+, P, r.
Example:To start recording on a tape deck while
listening to a CD
While holding down BACKGROUND,
press 4 (or 5) and press r.
The numeric buttons are assigned to select the
functions as follows:
Numeric button Operates
1 CD player
2 DAT deck
3 MD deck
4 Tape deck A
5 Tape deck B
6 LD player
7 VCR (remote control mode VTR 1*)
8 VCR (remote control mode VTR 2*)
9 VCR (remote control mode VTR 3*)
0 TV
>10 DBS
* Sony VCRs are operated with a VTR 1, 2 or 3 setting.
These correspond to Beta , 8mm and VHS respectively.
= +
Changing the Factory Setting
of a FUNCTION Button
If the factory settings of the FUNCTION buttons (page
11) don't match your system components, you can
change them. For example, if you connect a Sony LD
player to the VIDEO 2 jacks, you can assign the VIDEO
2 button to set the remote to control the LD player.
Note that the settings of the TUNER and PHONO
buttons cannot be changed.
Numeric
buttons
0 ) =
1
Holding down the SYSTEM CONTROL/
FUNCTION button whose function you want to
change (VIDEO 2, for example).
2
Press the corresponding numeric button of the
component you want to assign to the SYSTEM
CONTROL/FUNCTION button (6 - LD player,
for example).
For the numeric buttons, see the table in
"Operating One Component While Using
Another."
Now you can use the VIDEO 2 button to control
your Sony LD player.
To reset the setting to the factory setting
Repeat the above procedure.
SYSTEM
CONTROL/
FUNCTION
+
23 EN