Table of Contents
Advertisement
9 SPECIAL FEATURES
9.1 RESIN REGENERATION CYCLE
The regeneration cycle is activated by pressing the button shown in the figure, for at least 5 seconds.
For this key to be enabled parameter
At this point you can enter the number of wash cycles that can be performed after each regeneration: param-
eter
in the counters family
set number of cycles the message
information-only message with no effect on operation of the appliance, so you can continue to use the dish-
washer). The message is cleared when the regeneration cycle is terminated.
The number of regeneration cycles performed can be checked by consulting the parameter
family of counters.
When there are just 15 cycles remaining before the next regeneration cycle, at the end of the wash cycle the
display shows the message
and
, and so forth, i.e. the display informs the user of the number of wash cycles still available before resin
regeneration is required.
Before starting the regeneration cycle remove the siphon spillway.
WARNING:
If the regeneration cycle is accidentally started, it can be switched off by pressing the button shown in
the figure, for at least 5 seconds
The hardness of the water exiting the softener can vary between 3°f - 10 °f / 1.7 °d - 5.6 °d / 2.1 °e - 7 °e.
9.2 MEDICAL LINE DISHWASHER WITH DOOR/HOOD LOCK DEVICE
The medical line dishwasher with door/hood lock device has a device that prevents door/hood opening for the
entire duration of the work cycle.
For the door/hood lock to be active, the parameter
The dishwasher door/hood is locked at the start of a wash cycle and is released at the end of the final pause
after rinse. The wash compartment can be accessed by stopping the work cycle in progress, as the locking
device is thus disabled. .
A pause at the end of rinse can be set by means of the parameter
is common to all 3 wash cycles. The rinse water temperature is displayed during this pause. Another final
pause in the cycle can be set by setting the parameters
shows the time remaining for completion of the cycle. The door/hood lock device will be deactivated at the end
of the final pause (
For correct performance of the wash cycle the pause at the end of rinse and the final pause must assume the
default values (see Prog 032 – 034 - 035).
9.3 DETERGENT AND RINSE AID LEVEL SENSORS ACTIVATION
By setting the parameter
external detergent and rinse aid tanks is enabled. During the rinse phase, when the rinse aid inside the tank
has finished, the message
When the detergent inside the tank is finished, the message
cycles equal to
fore the detergent level in the tank must be restored.
DOC. NO. 5956.65J.00
EFS - Dishwashing Systems Platform
Electrolux Professional
. If
followed by
,
,
).
(in the
appears on the display.
(in the
family) the dishwasher inhibits the activation of other wash cycles. There-
TANK
BOILER
(in family
) must be set to 1.
is set to zero the counter is disabled, otherwise after the pre-
is displayed to confirm that regeneration is possible (this is an
, at the end of the next wash cycle the display shows
(in the
,
family) to 1, management of the level sensors located inside the
family) must be set to
(in the
family). This parameter
,
. During the final pause the display
is displayed and after a number of wash
in the
.
P. 21 / 174
Hide quick links:
Advertisement
Table of Contents
