Cisco Catalyst 2960-X Series Hardware Manual page 18

Use this cable for the RPS: CAB-RPS2300-E.
Cisco RPS 2300

Cisco RPS 2300
The Cisco RPS 2300 is a redundant power system that can support six external network
devices and provide power to one or two failed devices at a time. It senses when the
internal power supply of a connected device fails and provides power to the failed device,
preventing loss of network traffic. For more information, see the Cisco Redundant Power
System 2300 Hardware Installation Guide on Cisco.com at this URL:
www.cisco.com/en/US/products/ps7148/prod_installation_guides_list.html
The Cisco RPS 2300 has two output levels: –52 V and 12 V with a total maximum output
power of 2300 W.
All supported and connected switches can simultaneously communicate with the RPS 2300.
You can configure these RPS 2300 features through the switch software:
Enable RPS active or standby mode for each connected switch

Configure switch priority for RPS support

List the connected switches and the power-supply module sizes

Obtain reports when a switch is powered by the RPS

Obtain status reports for the RPS power-supply module

Read and monitor backup, failure, and exception history

AC Power Connector
Note
The switch is powered through the internal power supply. The internal power supply is an
autoranging unit that supports input voltages between 100 and 240 VAC. Use the supplied
AC power cord to plug it into an AC power outlet.
Power Supply Modules (Applies to the Catalyst 2960-XR Switches)
The switch operates with either one or two active power supply modules. You can use two
AC modules, or one module and a blank cover.
Note
The Catalyst 2960XR-48FPD-I and 2960XR-48FPS-I only support the PWR-C2-1025WAC power s
You cannot use the PWR-C2-250WAC and PWR-C2-640WAC power supplies in these switches.
This applies to the Catalyst 2960-X switches.
http://