Specifications - Sony HT-DDW900 Operating Instructions Manual

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 6 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than
0.7% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
1)
Power Output
Models of area code U, CA
(6 ohms 1 kHz, THD 0.7%)
2)
FRONT : 90 W/ch
2)
CENTER : 90 W
2)
SUR : 90 W/ch
(6 ohms 1 kHz, THD 10%)
2)
FRONT : 140 W/ch
2)
CENTER : 140 W
2)
SUR : 140 W/ch
1)
Measured under the following conditions:
Area code Power requirements
U, CA 120 V AC, 60 Hz
2)
Depending on the sound field settings and the
source, there may be no sound output.
Inputs (Analog)
MULTI CH IN, Sensitivity: 800 mV
SA-CD/CD, Impedance: 50 kohms
MD/TAPE, DVD,
VIDEO 1, 2, 3
Inputs (Digital)
DVD (Coaxial) Sensitivity: –
Impedance: 75 ohms
VIDEO 1, 2 Sensitivity: –
(Optical) Impedance: –
Outputs (Analog)
MD/TAPE (OUT), Voltage: 800 mV
VIDEO 1 (AUDIO Impedance: 10 kohms
OUT)
SUB WOOFER Voltage: 2 V
Impedance: 1 kohm
Reproduction frequency range
28 - 20,000 Hz
Tone
Gain levels ±6 dB, 1 dB step
FM tuner section
Tuning range 87.5 - 108.0 MHz
Antenna FM wire antenna
Antenna terminals 75 ohms, unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
Models of area code U, CA
With 10-kHz tuning scale:
530 – 1,710 kHz
With 9-kHz tuning scale:
531 – 1,710 kHz
Antenna Loop antenna
Intermediate frequency
450 kHz
3)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press ?/1. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the
procedure.
Video section
Inputs/Outputs
Video: 1 Vp-p, 75 ohms
COMPONENT VIDEO:
Y: 1 Vp-p, 75 ohms
P
B
75 ohms
P
R
75 ohms
80 MHz HD Pass Through
3)
3)
/C /B-Y: 0.7 Vp-p,
B
/C /R-Y: 0.7 Vp-p,
R
continued
71
US