GMC Savana 2020 Owner's Manual page 32

3. If equipped, release the pin
from the lock ring by pushing
down on the top of the ring and
lifting the lock tab from the ring.
4. Pull the pin handle up to
disengage the pin from the
retaining clip, and then pull the
pin out.
5. Repeat this procedure for the
other pins.
6. Pull the seat rearward about
5 cm (2 in), and then lift the
seat from the floor rails.
7. Remove the seat from the
vehicle.
8. For the second and third row
seats, stow the seat belt latch
by attaching the clip on the
seat belt latch to the trim just
inside the side door.
For the last row of seats, stow
the seat belt latch plate on the
clip at the window trim. Roll the
mini-latch into the seat belt
webbing and then hook the
seat belt latch plate on the clip.
Seats and Restraints
Reinstalling the Rear Seats
Warning
A seat that is not locked into
place properly can move around
in a collision or sudden stop.
People in the vehicle could be
injured. Be sure to lock the seat
into place properly when
installing it.
Warning
A seat belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. After raising the
rear seatback, always check to be
sure that the seat belts are
properly routed and attached, and
are not twisted.
31