Sony DAV-X1V Operating Instructions Manual page 75

8
Press C/X/x/c to select [YES] or [NO],
then press .
x The measurement is OK.
Disconnect the calibration mic, then select
[YES]. The result is implemented.
The distance and audio level of the front
speaker (L) and (R), and the audio level of
the subwoofer are displayed. (The distance
values are expressed in feet and meters for
North American models, and meters for
European models.)
Measurement complete.
FRONT L :
FRONT R :
SUBWOOFER :
If OK, unplug calibration mic and select
"YES".
YES
x The measurement is not OK.
Follow the message, then select [YES] to
retry.
Measurement failure.
Check front speaker connection.
Retry?
YES
NO
Note
• While the Auto Calibration function works:
– do not turn off the power.
– do not press any button.
– do not change the volume.
– do not change the function.
– do not change the disc.
– do not insert or eject a disc.
– do not disconnect the calibration mic.
• Depending on the acoustics of the room, the
displayed distance may not represent the actual
distance.
16ft 4.8m 0.0dB
16ft 4.8m 0.0dB
+ 4.0dB
NO
To select the auto calibration
setting mode
You can select the auto calibration setting mode.
1
Press AMP MENU.
2
Press X/x repeatedly until "A.CAL MODE"
appears in the front panel display, then
press or c.
3
Press X/x to select a setting.
• ON: reflects the setting that is set by the auto
calibration. When you adjust the woofer
level using BASS/TREBLE (page 38) when
set to "ON," each time you set this function
from "OFF" to "ON," the adjusted value is
restored.
• OFF: returns the woofer level to 0 dB,
regardless of the speaker setting made by
the auto calibration function.
4
Press .
5
Press AMP MENU.
The AMP menu turns off.
Tip
• When you perform [AUTO CALIBRATION],
"A.CAL MODE" is set to "ON" automatically.
75
US