Installing The Coffee Machine - Miele CVA 6401 Operating And Installation Instructions

Installing the coffee machine


Make sure that there is no power
supply to the machine during instal-
lation. This also applies when unin-
stalling!
The machine may only be operated
when installed and in an ambient
temperature range between +50°F
(10°C) to +100°F (38°C).
For installation, you will require two
hex keys in sizes 3 and 5.
To ensure the appliance door is flush
with the cabinetry front, a seal around
the building-in niche is needed or a
sealing strip must be adhered to the
coffee system.
 If there is not a seal at the front of the
building-in niche, adhere the Miele
sealing strips from the back (see pic-
ture) before installing the coffee sys-
tem.The sealing strips can be pur-
chased from Miele.
Sealing strips are available from your
Miele dealer or from Miele.
Tip: It is helpful to place the coffee ma-
chine somewhere at the same height as
the built-in niche. This will make it eas-
ier to connect the machine to the elec-
trical supply.
 Using the large hex key, unscrew all
four feet on the underside of the ap-
pliance by about 3/4" (2 mm).
The feet can be unscrewed by up to
approx. 4" (10 mm).
 Connect the appliance to the electri-
cal supply.
Ensure the power cord does not get
damaged when pushing the appli-
ance into the niche.
 Push the coffee machine all the way
into the built-in niche.
 Make sure the coffee machine is cen-
tered and straight in the built-in niche.
If this is not the case, align the ma-
chine using the four feet.
Installation
89