Listening To The Radio; Preset Tuning; Manual Tuning - Sony CMT-NE3 Operating Instructions Manual

To change the AM tuning interval
(except for European model and
Saudi Arabian model)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the power by pressing ?/1. While
holding TUNING +, press ?/1. When you
change the interval, all the AM preset stations
are initialized. To reset the interval, repeat the
same procedure.
Note
You cannot change the setting in Power Saving Mode.
Tips
• The preset stations are retained for about half a day
even if you disconnect the power cord or if a power
failure occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.

Listening to the radio

You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station

— Preset Tuning

Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 12).
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press TUNING MODE repeatedly until
"PRESET" appears in the display.
3
Press +/– (or TUNING +/– on the unit)
repeatedly to select the desired preset
station.
Listening to non-preset radio
station

— Manual Tuning

1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press TUNING MODE repeatedly until
"AUTO" and "PRESET" disappear from
the display.
3
Press +/– (or TUNING +/– on the unit)
repeatedly to tune in the desired
station.
continued
GB
13