Recording A Tape On An Md - Tape-Md Synchro Recording - Sony CMT-J3MD Operating Instructions Manual

Recording a tape on an
MD
— TAPE-MD Synchro Recording
You can make an analogue recording of a tape on
an MD. You can use TYPE I (normal), TYPE II
(CrO ) or TYPE IV (metal) tape, since the tape
2
deck automatically detects the tape type.
To turn on the system, press ?/1 (power).
?/1 (power)
`/1
HS
h
3 4,5
1
Insert a recordable MD.
With the arrow
pointing
toward the
deck
With the label
side up, and
the shutter on
the righthand
side
s MD A
l m M L
A
HS
H
A
A
HS HS
S
h H
A
2
Press to open the cover and insert a
tape.
3
Press SYNCHRO REC repeatedly until
"TAPE-MD SYNC ?" appears.
4
Press ENTER/START.
The MD deck stands by for recording and the
tape deck pauses for play.
Tape playback side
* >>> appears for the top side, and <<< for
the bottom side. To play the side not
indicated, press s and remove the cassette
to reverse the tape side, then perform steps
3 and 4 again.
5
Press ENTER/START again.
Recording starts. When the recording is
completed, the tape deck and the MD deck
stop automatically.
To stop recording
Press s.
Tips
• If you use a partially recorded MD, recording starts
after the recorded tracks.
• If the Smart Space function is on and there is no
sound input for about 3 seconds or more (but less
than 30 seconds) while recording, the MD deck
replaces this silence with a blank of about 3 seconds
and continues recording. However, this function
may not activate if there is noise.
L
M
m
l
continued
17