Advertisement
IMPORTANT: If the air inlet, hose or telescopic tube is blocked, switch off the vacuum cleaner and remove the
blockage(s) before re-starting the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat
will automatically turn the unit off. Should this occur, unplug the vacuum cleaner from the electrical socket and turn
off the switch. Remove and empty the dirt container. Check the hose for blockages. Clean the filters. Allow the unit to
cool for approximately one hour (if you have washed the filters you will need to wait twenty four hours for the filters
to dry before putting them back in the machine). To re-start the machine, plug it into an electrical socket and switch it
back on.
Emptying and cleaning the dirt container
Remove dirt container
by pushing down the dirt
container release button and
lifting the dirt container.
Cleaning the pre-motor filter
1
Hold the dirt container and
twist the lid anti-clockwise.
4
Tap excess dirt from the filter. Rinse under a tap and leave to dry for 24 hours.
Taking care of your machine – Filters
Hold the dirt container over a bin and press the dirt release latch
(located at the rear of the dirt container).
2
Lift the lid to reveal the
pre-motor filter.
5
40˚C
MAX
3
Lift out the pre-motor filter.
6
24hr
IMPORTANT: Water
temperature should
not exceed 40°C when
washing pre-motor filter.
IMPORTANT: Ensure
filters are completely dry
before inserting back into
the vacuum cleaner.
Hide quick links:
Advertisement
