Location Text - Honeywell Morley-IAS ZX Series Commissioning Manual

MORLEY-IAS
•
Press the appropriate number to select the required option. Press 'No' to return to the device
information display.
NOTE: This change facility is only available while in the configure mode. It cannot be invoked from the INSPECT
option, thus preventing inadvertent changes to the system.
5.2.4.2

Location Text

•
To enter or modify the location text assigned to a device, press '1' to select the 'Sensor Text' option. The
display will show the current location text and provide additional information to assist in making any changes.
•
Three modes of text entry are available – 'KeyWords', 'Numbers' and 'Letters'. The mode currently in use is
always shown in square brackets in the top right hand corner of the display. The required mode is selected
by pressing either the' Yes' (KeyWords) button or the 'No' (Letters/Numbers) button.
---------------------------------------------
Text = "FLOOR 2 ROOM 86_
Type in number 0..9, space or erase
A) Numbers
•
The number mode allows you to add numbers 0 to 9 on the display.
•
Advance (>) and Backspace (<) editing keys are also available in this mode.
•
For example, to change from 'ROOM 86' to 'ROOM 87', first press the backspace key once to erase
the '6', then press key '7'. The display will immediately show the new description as below:
---------------------------------------------
Text = "FLOOR 2 ROOM 87_
Type in number 0..9, space or erase
•
The cursor symbol '_' indicates where you are on the line. It will not appear in the description shown
on the device display.
B) Letters
•
Any letter in the alphabet can be entered from the Letter Mode. Pressing the appropriately-labelled
key enters letters A to M. To obtain letters N to Z, first hold down the 'Shift' key before pressing the
required letter.
---------------------------------------------
Text = "FLOOR 2 MAIN CORRIDOR_
Type in letter (Hold in shift FOR N..Z)
•
If you are in letter mode and wish to remove any previously entered text or add spaces, change to
number mode, use the '<' key to erase the text, or the '>' key to insert a space then return to letter mode.
C) KeyWords
•
This mode is selected by pressing the 'Yes' (KeyWords) key. The mode is again confirmed in the box
at the top right of the display.
•
KeyWords mode provides a quick means of entering frequently-used text with a single keystroke.
Page 20
[ Panel in Commissioning mode ]
[ Panel in Commissioning mode ]
[ Panel in Commissioning mode ]
Document No. 996-175-000-1, Revision 01
ZX Fire Alarm Control Panels
"[Numbers ]
"[Numbers ]
"[Letters ]
Commissioning Manual