Fading In Or Out - Sony CDP-XA20ES Operating Instructions Manual

4
When you record on both sides of the tape, press
EDIT/TIME FADE again.
The player inserts a pause, then creates the
program for side B. The display shows the
programmed tracks.
When you record on one side of the tape or on a
DAT or MD, skip this step.
5
Start recording on the deck and then press
the player.
When you record on both sides of the tape, the
player pauses at the end of the program for side A.
6
When you record on side B, reverse the tape and
press or on the player to resume playing.
To cancel Time Edit/Just Edit
Press PLAY MODE repeatedly until "SHUFFLE" and
"PROGRAM" disappear from the display (or press
CONTINUE on the remote).
You can program the tracks you want in advance
Select the tracks before doing the above procedure. The
player creates a program from the remaining tracks. In
this case, you cannot select "HALF" to specify the tape
length.
You can freely specify the tape length
Set the tape length using
Example: When the tape length of one side is 30 minutes
and 15 seconds
1 To set the minutes, turn
until "30" appears in the display, then push
AMS
2 To set the seconds, turn
until "15" appears in the display, then push
AMS
When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
You can automatically insert a blank space of 3
seconds between each track
Use the Auto Space function (see page 16).
You can check and change the program
See pages 12 and 13.
on
AMS .
AMS
.
AMS
.
Recording From CDs
Recording From CDs

Fading In or Out

You can manually fade in or out to prevent tracks from
starting or ending abruptly.
Note that you cannot use this effect when you use the
DIGITAL OUT connector.
To Press FADER
Start play fading in During pause.
the display and the
flashes. The play fades in.
End play fading out When you want to start fading out.
FADE
the
fades out and the player pauses.
Changing the fading time
You can change the fading time from 2 to 10 seconds
before fading in or out. If you don't change it, fading
lasts for 5 seconds.
1
Press FADER before you start playing.
"5 SEC" appears and "
display.
2
Press or to specify the fading time.
Fading out at the specified time
(Time Fade)
You can have the player fade out automatically by
specifying the playing time. Once you set the Time
Fade, it works twice, that is, the play fades out at the
end of both sides of a tape.
1
Press EDIT/TIME FADE repeatedly before you
TIME
start playing until "
FADE
indication appear in the display.
/ FADER
EDIT/TIME FADE
lights up in
FADE
indication
lights up in the display and
indication flashes. The play
" flashes in the
FADE
A
" and "A" in the
(Continued)
EN
15