To Close The Front Panel; To Remove The Front Panel; To Open The Service Cover; To Remove The Front Grille - Daikin FTXTA30A2V1BW Installation Manual

5 Installation
2 Pull down both locks on the back of the front panel.
3 Open the front panel until the support fits into the fixing tab.
a
a Lock (1 on each side)
b Backside of the front panel
c Fixing tab
d Support
5.1.2

To close the front panel

1 Lift the front panel slightly and remove the support from the
fixing tab.
a Backside of the front panel
b Fixing tab
c Support
2 Close the front panel.
3 Gently press the front panel down until it clicks.
5.1.3

To remove the front panel

INFORMATION
Remove the front panel only in case it MUST be replaced.
1 Open the front panel. See
page 3.
2 Open the panel locks located on the back side of the panel
(1 on each side).
a
a Panel lock
3 Push the right arm lightly to the right to disconnect the shaft
from the shaft slot on the right side.
Installation manual
4
b
c
d
a
"5.1.1 To open the front panel" on
a
a
a Arm
b Shaft
c Shaft slot
4 Disconnect the front panel shaft from the shaft slot on the left
side.
a
a Arm
b
b Shaft slot
c
c Shaft
5 Remove the front panel.
6 To re-install the front panel perform the steps in the opposite
order.
5.1.4

To open the service cover

1 Remove 1 screw from the service cover.
2 Pull out the service cover horizontally away from the unit.
a
b
a Service cover screw
b Service cover
5.1.5

To remove the front grille

CAUTION
Wear protective gloves.
1 Open the front panel. Refer to
panel" on page 3.
2 Remove the service cover. Refer to
cover" on page 4.
3 Remove the wire harness from the wire clamp and the
connector.
4 Remove the flap by pushing it to the left side and towards you.
5 Remove the 2 screw covers using a long flat plate such as a
ruler wrapped in a cloth and remove 2 screws.
b
c
b c
"5.1.1 To open the front
"5.1.4 To open the service
FTXTA30A2V1BW
Split system air conditioner
3P482320-9M – 2019.04