6: Inserting The Wireless Transmitter/Transceiver - Sony STR-DN2010 Manual de instrucciones Operating Instructions Manual

6: Inserting the wireless
transmitter/transceiver
To use the S-AIR function, you need to insert
the wireless transmitter (not supplied) into the
S-AIR main unit (this receiver) and the
wireless transceiver (not supplied) into the
S-AIR sub unit.
Notes
• Before inserting the wireless transmitter/
transceiver, be sure to disconnect the AC power
cord (mains lead).
• Do not touch the terminals of the wireless
transmitter/transceiver.
To insert the wireless
transmitter into the S-AIR main
unit
1
Remove the screws and detach the slot
cover.
GB
36
Slot cover
Notes
• Remove the screws on the slot cover pointed
with g and G marks. Do not remove other
screws.
• The slot cover is no longer necessary.
However, keep it after detaching.
2
Insert the wireless transmitter.
EZW-T100 slot
Wireless transmitter
Notes
• Insert the wireless transmitter with the S-AIR
logo facing up.
• Insert the wireless transmitter so that the V
marks are aligned.
• Do not insert other than the wireless
transmitter into the EZW-T100 slot.
3
Use the screws that you removed from
step 1 to fasten the wireless
transmitter.
Note
Do not use other screws to fasten the wireless
transmitter.
To insert the wireless
transceiver into the S-AIR sub
unit
Refer to the operating instructions supplied
with the surround amplifier and S-AIR
receiver.