Sony STR-DE805G Operating Instructions Manual page 7

Understanding How the Receiver Works: STR-DE805G
The remote control supplied with the STR-DE805G uses infrared (IR) rays to command the receiver and control the
on-screen display.
Since this receiver uses menu operations, you must connect a TV.
LD player, etc.
Video signal
Video signal
VCR, etc.
On-screen operation
1
The remote commander emits an infrared (IR) signal when you press direction control button (1 above).
2
This controls the movement of the pointer (hand icon) in the on-screen display (2 above).
3
When you move the pointer to an on-screen icon, and press the center of the direction control button, the
infrared (IR) repeater transmits the corresponding IR control code to the respective program source (3 above).
If the screen does not appear or the pointer does not move when you press the direction control button
The IR code from the remote is not fully reaching the infrared receptor on the receiver (1 above). Make sure there are no
obstacles between the remote and the receiver.
If the program source fails to respond or is slow to respond
The IR control code from the IR repeater is not fully reaching the infrared receptor on the program source. Connect the extra IR
repeater (supplied) and position it facing the program source (see "IR Repeater Hookups" on page 9).
If some of the programmed on-screen controls are unresponsive or slow, rerecord the IR codes for those buttons ( see
"Registering non-Sony Audio/Video equipment" on page 19).
IR control codes
STR-DE805G
3
IR repeater
1
and receptor
Introduction
Video signal (Input from source
components combined with on-screen
display)
S
O
U
N
D
0 (
TV (monitor)
Â
M PUSH m
ENTER
µ
FUNCTION
ALL
OFF
2
Â
VOL
+
M m
–
µ
SUB USER
) p P = +
7 EN