Learning The Commands Of Your Components - Sony STR-DE895 Operating Instructions Manual

Learning the commands
of your components
(RM-PG412 only)
By using the Learning function, it is possible
for this remote to perform learned commands.
Setting remote control codes that
are not stored in the remote
When a remote control code is not one of the
presets stored in the remote, it is possible for
the remote to learn the code using the Learning
function.
1
Press TV ?/1 while pressing down USE
MODE.
The indicator lights.
2
Press the input selector button
(including TV ?/1) for the component
you want to learn functions for.
For example, if you are going to learn an
operation for a CD player, press CD/SACD.
3
Press the button you want to use for
the Learning function.
The indicator turns off while a valid button
is pressed, then blinks slowly.
4
Point the remote control code receiver
section of the remote towards the
receiver/transmitter on the remote
control to be learned.
GB
54
5-10 cm
5
Press the appropriate button on the
remote control to be learned to send
the remote button code.
Lightly pressing the button once should be
sufficient.
If learning is completed successfully, the
indicator slowly flashes twice and the
remote automatically exits the learning
mode.
When learning is not completed
successfully, the indicator flashes 4 times in
quick succession and the procedure returns
to step 5.
If the memory of the remote is already full,
the indicator flashes 8 times in quick
succession and the remote automatically
exits the learning mode.
Notes
• You can program more than 80 keys for the
Learning function. In some cases, you may not be
able to program even if you have not programmed
80 buttons. The number of buttons you can program
for each input selector button are shown in the
following table.
Input selector
button area
VIDEO 1, VIDEO 2,
DVD
VIDEO 3, TV/SAT,
TAPE
MD/DAT, CD/SACD,
TUNER
PHONO, MULTI CH
TV buttons (TV ?/1,
TV VOL +/–, TV CH +/–,
WIDE, TV/VIDEO)
• In steps 2 and 3, the indicator turns off while a valid
button is pressed.
• In step 3, if several buttons that can be used for
learning are pressed, only the last pressed button is
valid. The indicator blinks slowly, it turns ON while
a valid button is pressed.
• In step 5, if a button that can be used for learning is
pressed, the new button is selected and the learning
procedure returns to the beginning of step 5.
Number of Buttons
you can program
78 keys
78 keys
78 keys
52 keys
7 keys