Specifications - Sony STR-DE197 Marketing Operating Instructions Manual

Specifications

AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power Output
Models of area code U, CA
Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
Models of area code CEL, CEK
Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
1) Measured under the following conditions:
Area code
U, CA
CEL, CEK
Frequency response
CD, MD/TAPE,
VIDEO 1, 2
Inputs (Analog)
CD, MD/TAPE,
VIDEO 1, 2
2) INPUT SHORT (with bass boost and tone
bypassed).
3) Weighted network, input level.
GB
26
1)
125 W + 125 W
1)
100 W + 100 W
Power requirements
120 V AC, 60 Hz
230 V AC, 50 Hz
20 Hz – 50 kHz
+0/–0.5 dB (with bass
boost and tone bypassed)
Sensitivity: 500 mV
Impedance: 50 kiloohms
2)
S/N : 85 dB
3)
(A, 500 mV )
Outputs (Analog)
MD/TAPE (OUT),
VIDEO 1 (AUDIO OUT)
Bass Boost:
Tone:
FM tuner section
Tuning range
Antenna
Antenna terminals
Intermediate frequency
Sensitivity
Mono:
Stereo:
Useable sensitivity
S/N
Mono:
Stereo:
Harmonic distortion at 1 kHz
Mono:
Stereo:
Separation
Frequency response
Selectivity
AM tuner section
Tuning range
Models of area code U, CA
With 10-kHz tuning scale: 530 – 1,710 kHz
With 9-kHz tuning scale: 531 – 1,710 kHz
Models of area code CEL, CEK
With 9-kHz tuning scale: 531 – 1,602 kHz
Antenna
Intermediate frequency
Usable sensitivity
S/N
Harmonic distortion
Selectivity
At 9 kHz:
At 10 kHz:
4) You can change the AM tuning scale to 9 kHz or 10
kHz. After tuning in any AM station, turn off the
receiver. While holding down PRESET TUNING +,
press ?/1. All preset stations will be erased when
you change the tuning scale. To reset the scale to 10
kHz (or 9 kHz), repeat the procedure.
Voltage: 500 mV
Impedance: 10 kiloohms
+8 dB at 70 Hz
±10 dB at 100 Hz and
10 kHz
87.5 – 108.0 MHz
FM wire antenna
75 ohms, unbalanced
10.7 MHz
18.3 dBf, 2.2 µV/75 ohms
38.3 dBf, 22.5 µV/75 ohms
11.2 dBf, 1 µV/75 ohms
76 dB
70 dB
0.3%
0.5%
45 dB at 1 kHz
30 Hz – 15 kHz,
+0.5/–2 dB
60 dB at 400 kHz
4)
4)
Loop antenna
450 kHz
50 dB/m (at 1,000 kHz or
999 kHz)
54 dB (at 50 mV/m)
0.5% (50 mV/m, 400 Hz)
35 dB
40 dB