Sony STR-DA3000ES Operating Instructions (STRDA3000ES) Operating Instructions Manual page 45

Nevertheless, each listening environment has many
variables, like wall reflections, and you may obtain
better results using "BEHD" if your speakers are
located high above the listening position, even if they
are to the immediate left and right.
Therefore, although it may result in a setting contrary
to the above explanation, we recommend that you
playback multi channel surround encoded software and
select the setting that provides a good sense of
spaciousness and that best succeeds in forming a
cohesive space between the surround sound from the
surround speakers and the sound of the front speakers.
If you are not sure which sounds best, select "BEHD"
and then use the speaker distance parameter and
speaker level adjustments to obtain proper balance.
x SP CROSSOVER > XXX Hz
(Speaker crossover frequency)
Initial setting: 100 Hz
Lets you set the bass crossover frequency of speakers
set to "SMALL" in the SPEAKER SET UP menu. You
can adjust from 40 Hz to 160 Hz in 10 Hz steps.
Advanced SURR SET UP menu
parameters
When "MENU EXPAND" is set to "ON", all of
the following parameters are displayed and
adjustable.
See page 39 for the SURR SET UP menu
adjustments. Initial settings are underlined.
All SURR SET UP menu
parameters
EFFECT LEVEL
C. WIDTH L_C_R*
DIMENSION F_I_S*
PANORAMA MODE*
FRONT REVERB*
SCREEN DEPTH*
VIR.SPEAKERS*
A.F.D. 2CH SW*
* Adjustable only when "MENU EXPAND" is set to
"ON".
x C. WIDTH L_C_R
(Center width control)
Initial setting: (3)
Lets you perform further adjustments for Dolby Pro
Logic II Music mode decoding. You can set this
parameter only when A.F.D. mode is set to "PRO
LOGIC II MUSIC" (page 33).
You can adjust the distribution of the center channel
signal, generated through the Dolby Pro Logic II
decoding, to the L/R speakers.
x DIMENSION F_I_S
(Dimension control)
Initial setting: midpoint (0)
Lets you perform further adjustments for Dolby Pro
Logic II Music mode decoding. You can set this
parameter only when A.F.D. mode is set to "PRO
LOGIC II MUSIC" (page 33).
You can adjust the difference between the front
channels and the surround channels.
x PANORAMA MODE
(Panorama mode)
Lets you perform further adjustments for Dolby Pro
Logic II Music mode decoding. You can set this
parameter only when A.F.D. mode is set to "PRO
LOGIC II MUSIC" (page 33).
• ON
Lets you enjoy the surround sound by spreading the
sound field of front speakers to the left and right of
the listening position (panorama mode).
• OFF
Panorama mode is not activated.
x FRONT REVERB (Front reverberation)
This parameter is especially for "D.CONCERT HALL
A/B" (page 35). This parameter lets you adjust the
amount of reverberations to add to the front signals
according to the original reverberations in the source.
• STD
Normally, select "STD".
• WET
Select to increase front reverberations.
x SCREEN DEPTH (Screen depth)
Lets you create the sensation that the sound of the front
speakers comes from inside the screen in your listening
room, like theatres.
• ON
Lets you create the sensation that the sound comes
from a very large screen with a great amount of
screen depth.
• OFF
This function is not activated.
Note
This parameter is only available for Cinema Studio EX
modes.
x VIR.SPEAKERS (Virtual speakers)
This parameter is especially for the Cinema Studio EX
modes (page 34).
• ON
The virtual speakers are created.
continued
GB
45