Sony R-DG1200 Operating Instructions Manual page 66

5
Press V/v repeatedly to select
the speaker pattern you want.
Making settings with the Test
Tone menu
2CH/ 2CH/
A.DIRECT A.DIRECT A.F.D. A.F.D.
INPUT INPUT
RESOLUTION RESOLUTION MODE MODE
1
Press GUI MODE repeatedly to
select "GUI ON".
"GUI MODE" appears in the display
window of the receiver and the GUI menu
appears on the TV screen. Press MENU if
the GUI menu does not appear on the TV
screen.
2
Press V/v repeatedly to select
"Settings", then press
The Settings menu list appears on the TV
screen.
3
Press V/v repeatedly to select
"Speaker", then press
US
66
MOVIE MOVIE MUSIC MUSIC
NIGHT NIGHT
SLEEP SLEEP MODE MODE
GUI GUI
1
MODE MODE
2-7
HOME HOME
MENU
or b.
or b.
4
Press V/v repeatedly to select
"Test Tone", then press
5
Press B/b repeatedly to select
the test tone type, then press
.
6
Press V/v repeatedly to select
the speaker you want to adjust,
then press
The test tone is output from each speaker
in sequence.
7
Press V/v repeatedly to adjust
the parameter, then press
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–.
• The adjusted value is shown on the display
during adjustment.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely. Check to see if they are connected
securely and cannot be disconnected by
pulling on them slightly.
• The speaker cords may have the short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker displayed on the
screen
The speaker pattern to the connected speaker
is not set up correctly. Make sure the speaker
connection and the speaker pattern match.
.
.
.