Sony 3-289-204-12(1) Operating Instructions Manual page 70

Making settings with the Test
Tone menu
2CH/ 2CH/
A.DIRECT A.DIRECT A.F.D. A.F.D.
INPUT INPUT
RESOLUTION RESOLUTION MODE MODE
1
Press GUI MODE repeatedly to
select "GUI ON".
"GUI MODE" appears on the display
window of the receiver and the GUI menu
appears on the TV screen. Press MENU
if the GUI menu does not appear on the
TV screen.
2
Press V/v repeatedly to select
"Settings", then press
The Settings menu list appears on the TV
screen.
3
Press V/v repeatedly to select
"Speaker", then press
4
Press V/v repeatedly to select
"Test Tone", then press
b.
You can select the test tone type.
70 US
MOVIE MOVIE MUSIC MUSIC
NIGHT NIGHT
SLEEP SLEEP MODE MODE
GUI GUI
1
MODE MODE
2-6
HOME HOME
or b.
or b.
5
Press V/v repeatedly to select
the speaker you want to adjust,
then press
The test tone is output from each speaker
in sequence.
6
Adjust the parameter using V/v,
then press
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–. You can also
use MASTER VOLUME on the receiver.
• The adjusted value is shown on the display
during adjustment.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely. Check to see if they are connected
securely and cannot be disconnected by
pulling on them slightly.
• The speaker cords may have the short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker displayed on the
screen
The speaker pattern to the connected speaker
is not set up correctly. Make sure the speaker
or
connection and the speaker pattern match.
.
.