Sony 3-289-204-12(1) Operating Instructions Manual page 114

Item Explanation
EXIT Exits the setting process
without saving the
measurement results.
3
Select "SAVE EXIT" in step 2.
The measurement results are saved.
4
Press V/v repeatedly to select the Auto
Calibration Type, then press
Auto
Calibration
Type
FULL FLAT
ENGINEER
FRONT REF
OFF
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low frequency characteristics.
The measurement results may vary, depending on
the position of the optimizer microphone and
speakers, and the shape of the room. It is
recommended that you follow the measurement
results. However, you can change those settings in
the Speaker settings menu. Save the measurement
results first, then try to change the settings if you
want.
When you select "PHASE INFO."
You can check the phase of each speaker (in
phase/out of phase).
Press V/v repeatedly to select a speaker,
then press to return to step 1 in "To
confirm/save Auto Calibration when GUI
function is turned off".
114 US
.
Explanation
Makes the measurement of
frequency from each speaker
flat.
Sets the frequency
characteristics to a set that
matches that of the Sony
listening room standard.
Adjusts the characteristics of
all the speakers to match the
characteristics of the front
speaker.
Set the Auto Calibration EQ
to off.
Display Explanation
window
xxx*:IN
The speaker is in phase.
xxx*:OUT The speaker is out of phase. The
"+" and "–" terminals of the
speaker may be connected the
other way around. However,
depending on the speakers,
"xxx:OUT" appears on the
display even though the speakers
are connected properly. This is
because of the speakers'
specifications. In this case, you
can continue to use the receiver.
xxx*– – – No speakers are connected.
* xxx represent a speaker channel.
FL Front Left
FR Front Right
CNT Center
SL Surround Left
SR Surround Right
SB Surround Back
SBL Surround Back Left
SBR Surround Back Right
SW Subwoofer
Tip
Depending on the position of the subwoofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
Selecting a sound field type
For details on each sound field type, see
"Enjoying a pre-programmed sound field"
(page 59).
Press 2CH/A.DIRECT, A.F.D.,
MOVIE, or MUSIC repeatedly.
The selected sound field type appears on the
display.