Infrared (Ir) Repeater Hookups; Audio Component Hookups - Sony TA-VE810G Operating Instructions Manual

Hooking Up the System

Infrared (IR) Repeater Hookups

The IR repeater emits infrared signals corresponding to
those emitted by the remote controls supplied with the
components. Connect the IR repeater if:
• You experience difficulty controlling a certain
component using the on-screen display control.
• Your installation configuration prevents the IR
repeater on the amplifier's front panel from reaching
all of the components you need to control.
After connecting the IR repeater, set it above or below
the IR sensor on the component(s) to be controlled.
Each IR repeater can send infrared signals to one
component.
IR sensor
IR OUT
Note
Use the supplied adhesive tape to secure the IR repeater so
that its front faces the component to be controlled.
GB
6
IR repeater
µ
Component
infrared
signals
IR repeater(s)

Audio Component Hookups

If your components are Sony products, connect them to
the jacks as shown in the table on page 15 so that the IR
registration is unnecessary.
S-LINK/CTRL A1
e PHONO d TUNER a CD
What cords will I need?
Audio cord (not supplied)
White (L)
Red (R)
Ç : signal flow
a CD (to CD player)
Amplifier
IN
L
R
CD
b TAPE (to a tape deck)
Amplifier
RECOUT IN
L
R
TAPE
c DAT/MD b TAPE
White (L)
Red (R)
CD player
OUTPUT
LINE
Tape deck
OUTPUT INPUT
LINE LINE
L
R