Yanmar 3TNV Series Service Manual page 150

(3) Thrust bearing installation
1) Fit thrust bushing on turbine shaft 1.
2) Apply lubricating oil on the bearing portion of
thrust bearing 6 and install it in bearing housing
15.
3) Apply Locktite on the threaded portion of M3 Torx
T machine screw 17 for thrust bearing installation,
and use Torx torque driver for installation by
tightening to the specified torque.
Tightening torque: 1.3 0.1N-m (13 1kgf-cm)
(4) Seal plate installation
1) Fit the seal ring on oil thrower 2.
2) Insert oil thrower 2 into seal plate 4.
Note: The seal ring joint portion shall be positioned
as illustrated at right.
3) Apply liquid gasket (Three Bond No.1207) on the
seal plate mounting surface on the compressor
side of bearing housing 15.
Note: See the illustration below for the applying
position.
Applying thickness: 0.1 0.2 mm
4) Install seal plate 4 on bearing housing 15.
5) Apply Locktite on the threaded portion of M3
machine screw for seal plate mounting, and
tighten it with a torque screwdriver.
Tightening torque: 1.3 0.1N-m (13 1kgf-cm)
135
8. Turbochager