Servicing Points - Yanmar 3TNV Series Service Manual

4.4.4 Servicing points

Point1: Oil pan
[Disassemble]
Sealant is applied to the oil pan mounting surface
on the block. Carefully operate soas not to
damage or distort the bonding surface.
[Reassemble]
Apply sealant (code No.977770-01212) before
reassembly.
Point2: Piston w/rod
[Disassemble]
Measure the connecting rod side gap.
Standard
Carefully remove the carbon deposit on top of the
cylinder so as not to damage the inner side of the
cylinder.
Set the piston at the BDC position and remove the
connecting rod cap. Then set the piston at the
TDC position, and push the connecting rod big
end with the wooden shaft of a hammer.
Proceed carefully so as not to cause the cylinder
block catch the rod big end. Set the rod caps
and crankpin metals in their correct combinations.
[Reassemble]
Apply oil especially carefully to the sliding contact
surfaces of the pistons, rods and rings.
Use the piston insertion tool (see 12.1-9 in
Chapter 12) to insert each piston w/rod in the
cylinder block and install the bearing metal cap.
Rod bolt tightening torque
Model
3TNV82A
TNV84 88
4TNV94L･98
4TNV106(T)
Point3: mounting flange
[Disassemble]
Place the engine on a stable base with the cylinder
block upper surface facing down, and remove the
mounting flange carefully so as not to damage the
combustion surface.
mm
0.20 0.40
N m(kgf-m)
Standard (apply lube oil)
37.2 41.2 (3.8 4.2)
44.1 49.0 (4.5 5.0)
53.9 58.8 (5.5 6.0)
78.5 83.4 (8.0 8.5)
4. Disassembly, Inspection and Reassembly of Engines
91