Advertisement
6.
Slide the foot across until the
screw is located in the smaller
section of the keyhole. See fig 3A.
7.
Using a pozi-drive screw driver,
locate the taptite screw through
the hole provided as shown in Fig
3B.
8.
Note: At this stage the feet must
be parallel and pointing for-
wards. Tighten both screws se-
curely, ensuring they are located
correctly in the keyholes.
9.
Observe holes C,D,E, and F as
shown in fig 4, at the rear fixing
bracket of the floor standing foot.
10. Taking the 2.6mm drill bit supplied
in the fixing kit, drill four holes
through the body of the heater us-
ing holes C,D,E and F as a tem-
plate. Do not allow the drill bit to travel more than 5mm into the heater. Please
ensure the heater is gripped firmly and the feet remain in position.
11. Secure the back of the feet to the heater by fixing the four No.6 x 3/8" self tapping
screws provided through the holes C,D,E and F.
12. With the feet securely fixed to the heater, rotate the heater onto its feet and then re-
move the side packing.
13. Cable entry may be effected from either the right or the left side of the unit, but the cable
should be routed around the back of the foot and then fed through the appropriate
retaining clips.
FIG. 4
FIG. 3A
FIG. 3B
FRONT OF HEATER
D
C
FRONT OF HEATER
FRONT OF HEATER
F
E
83816 Issue 1 : 01.98
Advertisement
