Input Connectors - Sony HDW-M2000 Operation Manual

Specifications
Analog Betacam playback
Video
Bandwidth Y
R–Y/ B–Y
S/N ratio Y
R–Y/ B–Y
K factor (2T pulse)
Y
LF non-linearity
R–Y/ B–Y
Y/C delay
Audio
LNG Frequency response (at 10 dB
a)
below reference level
S/N ratio (at 3% distortion level)
Distortion (THD at 1 kHz reference
level a) )
Wow and flutter
AFM Frequency response (at reference
a)
level )
S/N ratio (at 3% distortion level)
Distortion (THD at 1 kHz reference
level a) )
a) Reference level: +4 dBm
Processor adjustment range
Video level ±3 dB/ –∞ to +3 dB selectable
Chroma level ±3 dB/ –∞ to +3 dB selectable
Setup level (59.94i, 29.97PsF mode)
±30 IRE
Black level (50i, 25PsF mode)
±210 mV
Chroma phase ±30°
System phase Sync: ±15 µs
SC: ±200 ns

Input connectors

HDSDI INPUT BNC (1 each for input and for
through output to a monitor)
Serial digital (1.485 Gbits/s)
SMPTE 292M
SDTI INPUT BNC (1) (optional)
SMPTE 305M (SDTI)
A-4
Appendix
Metal tape
30 Hz to 4.5 MHz +0.5 dB/ –4.0 dB
30 Hz to 1.5 MHz +0.5 dB/–3.0dB
51 dB or more
48 dB or more
2% or less
3% or less
4% or less
20 ns or less
Metal tape
50 Hz to 15 kHz +1.5 dB/ –3.0 dB
)
72 dB or more
1% or less
0.1% rms or less
20 Hz to 20 kHz +0.5 dB/–2.0 dB
85 dB or more
0.5% or less
Oxide tape
30 Hz to 4.1 MHz +0.5 dB/ –6.0 dB
30 Hz to 1.5 MHz +0.5 dB/–3.0 dB
48 dB or more
45 dB or more
3% or less
Oxide tape
50 Hz to 15 kHz +3.0 dB
50 dB or more (Dolby NR off)
2% or less
0.1% rms or less
REF. VIDEO INPUT
BNC (2 in loop through
connection)
Black burst or composite sync
0.3 Vp-p, 75 Ω, sync negative
AUDIO INPUT CH1/2/3/4
XLR 3-pin, female (4)
LOW OFF: –60 dBu, high
impedance, balanced
HIGH OFF: +4 dBu, high
impedance, balanced
HIGH ON: +4 dBm, 600 Ω
termination, balanced
CUE IN XLR 3-pin, female (1)
LOW OFF: –60 dBu, high
impedance, balanced
HIGH OFF: +4 dBu, high
impedance, balanced
HIGH ON: +4 dBm, 600 Ω
termination, balanced
–
–
–