Basic Operating; Switching On / Off; Standby Power Mode; Selecting Modes - JVC MX-D719PB Instruction Manual

Basic Operating

Switching ON / OFF

• Press button to switch the unit on. The display will show "ON". Then, the system will
switch to the last selected source.
• Press and hold
LOW" / "BATT HALF" / "BATT HIGH" / "BATT FULL").
• Press button to switch the unit back to standby mode. The display will show
"STANDBY" and then go blank.
While the battery level is low, the display will show BATT LOW every 30 seconds.

Standby Power Mode

The unit features an Standby Power mode. It automatically turns off if the unit is idle or the
external unit is disconnected, switched off or the volume is too close to mute for about
minutes.

Selecting Modes

Turn the SOURCE button to switch between TUNER (FM), LINE IN, USB and BT (Bluetooth®)
modes. The selected mode will show on the display.

Adjust the Speaker Level Settings and Effects

Adjusting the Volume
To increase or decrease the volume, turn the MASTER –VOLUME+ dial.
Preset Equalizer
During playback, press the EQ button repeatedly to select: ROCK /JAZZ / SAMBA / POP /
FLAT / FUNK.
BOOSTER
Press BOOSTER button to switch on/off the booster effect. The volume level will be
boosted immediately.
The EQ cannot work under BOOSTER mode. The display will show "EQ INVALID" if you press EQ button.

Adjust the LED light

Press the LIGHT button repeatedly to select the LED effect between LED1, LED2, LED3,
LED4, LED5, LED6 and OFF.
button to show the in-built battery status ("BATT EMPTY" / "BATT
15
13