Planer Controls And Adjustments; Jointer Controls And Adjustments - Jet JJP-12 Operating Instructions And Parts Manual

Figure 4

9.4 Planer controls and adjustments

Refer to Figure 5:
Power Feed
Placing the planer power feed handle (D) in the
up position turns the planer power feed on (see
arrow). Placing the handle in the down position
turns the power feed off.
Figure 5
Table Lock
Turn the table lock (E) clockwise to lock the
height adjustment handwheel (F) and secure the
planer table (C) in its selected position. Turn the
table lock (E) counterclockwise to release and
permit table adjustment.
Table Height Adjustment
The planer table height is set as follows:
1. Unlock the table lock (E).
2. Rotate the height adjustment handwheel (F)
clockwise to raise the planer table (C),
counterclockwise to lower.
3. Lock the table lock (E).
Each revolution of the handwheel (F) results in a
5/32" up or down movement of the table (C). A
scale on the handwheel column indicates the
amount of handwheel rotation. A pointer (B)
indicates the table position relative to the
cutterhead on the scale (A) located on the side
of the cabinet.

9.5 Jointer controls and adjustments

Refer to Figure 6:
Outfeed Table Height Adjustment
Lock knob (C) and lifting handle (B) control the
height adjustment of the outfeed table (A).The
outfeed table is initially adjusted at the factory
and should not be repositioned except during
certain adjustments. These are described in
sect. 10.1, Table and Knife Adjustments.
Infeed Table Height Adjustment
Lock knob (D) and lifting handle (E) control the
height adjustment of the infeed table (F).
To adjust:
1. Loosen lock knob (D).
2. Raise the lifting handle (E) to raise the
infeed table for a shallow depth of cut.
Lower the handle for a deeper cut.
3. Tighten the lock knob (D).
The infeed table lifting handle in the fully
lowered position results in a depth of cut of
5/32".
Note: A depth of cut of 1/16" or less is recom-
mended.
9
Figure 6