Assembly Fuselage - THUNDER TIGER Mister Mulligan 4321 Manual

ASSEMBLY / FUSELAGE
C
B
1. Locate firewall and cowling mounts B & C.
B
2. Epoxy the cowling mounts on firewall. Note the
cowling mount B is installed near the notch side
and use care when inserting the cowling mounts
in place or it may damage the foam mounts.
3. Here the back view of the firewall assembly. Note
the orientation of the cowling mounts.
4. Trial fit the firewall assembly in right fuselage half,
C
Face up
5
glue it in place with furnished epoxy. Hint: How to
tell the left or right of the fuselage? You can
image you are sitting in the cockpit then the right
fuselage is at right side.
5. Drill 3mm rudder pushrod exit hole at the right
fuselage tail. A small amount of angle will give
best pushrod performance.
6. Locate the pushrod support and drill 2mm holes
on the punch dots.
7. Locate the ser vo tray
then epoxy servo tray
and pushrod support on
left fuselage.
Note the pushrod suppor t orientation as
illustrated. You may use right fuselage to help
position the servo tray and pushrod support.
After it cured then remove the right fuselage
carefully.
See from front fuselage