Security Lock - Sony VPL-CX63 Operating Instructions Manual

Security Lock

The projector is equipped with a security
lock function. When you turn the power of
the projector on, you are required to input
the previously set password. If you do not
input the correct password, you will not be
able to project the picture.
Note
You will not be able to use the projector if you
forget your password and the password
administrator is not available. Be please aware
that using the security lock can prevent valid
usage in such cases.
To use the security lock
1
Press the MENU key and then, on the
INSTALL SETTING menu, turn on
the
"Security Lock"
2
Enter the password.
v/V/b/B
Use the MENU,
keys to enter the four-digit password.
(The default initial password setting is
"ENTER, ENTER, ENTER, ENTER."
After this is entered you can put in your
own password. Therefore, when you use
this function for the first time, please
input "ENTER" four times.)
Enter password key.
Password required for power-on.
Use:
Next, the screen for entering the new
password is displayed. (Enter the
password on this screen even if you want
to keep the current password.)
Enter the password on this screen.
setting.
, and ENTER
Cancel: Other key
Enter new password key.
Power-on cannot be performed
without the password.
Use:
3
Enter the password again to confirm.
Re-enter new password key.
Be sure to remember this password.
Use:
When the following message is
displayed, the setting for security lock is
completed.
If "Invalid Password!" is displayed on
the menu screen, perform this procedure
again from step 1.
4
Turn the main power off and
disconnect the AC power cord.
Cancel: Other key
Cancel: Other key
21
Security Lock