Projecting - Sony VPL-CX63 Operating Instructions Manual

Projecting

VPL-CX63
ON/STANDBY indicator
Rear remote
control detector
APA INPUT
KEY
STONE /TILT
LENS
ENTER
AUTO
RESET MENU
FOCUS
FREEZE
D ZOOM VOLUME
PIC AUDIO
MUTING MUTING
1
Plug the AC power cord into a wall
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
2
Press the ?/1 key.
The ON/STANDBY indicator flashes in
green.
3
Turn on the equipment connected to
the projector.
4
Press the INPUT key to select the
input source.
Each time you press the key, the input
signal switches as follows:
Input-AtInput-BtVideotS-Video
To input from
Computer connected to
the INPUT A connector
Computer connected to
the INPUT B connector
Video equipment
connected to the VIDEO
input connector
Video equipment
connected to the
S VIDEO input
connector
Smart APA (Auto Pixel Alignment)
adjusts the picture of the connected
equipment so that it is projected clearly.
Notes
• If "Auto Input Search" is set to "On," the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
For details, see "Auto Input Search"
on page 29.
• The Smart APA feature is effective for
the input signal from a computer only.
5
Switch the equipment connected to
output to the projector.
Depending on the type of your
computer, for example a notebook, or an
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys (e.g.,
/ /
LCD ,
VGA
your computer's settings.
Press INPUT
to display
Input-A
Input-B
Video
S-Video
, etc.), or by changing
Projecting
17