Connection Examples; Connecting Directly To The Projector - Sony VPH-D50HTM Operating Instructions Manual

Connection Examples

When making connections:
• Before connecting any cables, make sure that each
piece of equipment to be connected is turned off.
• Use cables appropriate for the equipment to be
connected.
• A loose connection may cause hum or noise.
• When disconnecting a cable, pull it out by the plug;
not the cable itself.
• Also refer to the instruction manual of the equipment
to be connected.

Connecting Directly to the Projector

TRIGGER
IN OUT
PLUG IN POWER
CONTROL S
Color monitor
Video equipment
42
(GB)
IN
ABL LINK
RS-422A
IN
REMOTE
to video input
to video output
to S Video output
Setting up
• Set INPUT-A in the SET SETTING menu to RGB and INPUT-B to
COMPONENT.
For details, see "The SET SETTING Menu" on page 34 (GB).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 28 (GB).
Connecting a BNC connector:
Rear
OUT
Y IN
C IN
R G B SYNC/HD VD
OUT IN OUT C /R-Y/P Y C /B-Y/P
R R B B
VIDEO S VIDEO INPUT A
to RGB output
Video equipment
2 Twist to the right.
1 Align the pins with the pin holes and
push the plug into the socket.
SYNC/HD
R G B VD
C /R-Y/P Y C /B-Y/P
R R B B
VIDEO Y C
INPUT B
to component output
Video equipment