Sony VPH-D50HTM Operating Instructions Manual page 13

Remote Control RM-PJD50
Selecting the input signal or video memory number
can be done easily.
A
VIDEO
1
SEL
4
7
1 0
INPUT
VIDEO MEMORY
SELECT
4
1 1 1 1 1 1 /u u u u u (on/standby) keys
Press the 1 key to turn on the power and the u key to
standby when the MAIN POWER switch on the
projector is set to ON.
2 INPUT SELECT keys
Select the input signal.
VIDEO: The video or S video signal input from the
VIDEO IN or S VIDEO IN (or Y/C IN) connectors
SEL (select): Select the signal input from the VIDEO
IN or S VIDEO IN (or Y/C IN) connectors by
pressing this key after pressing the VIDEO key.
A: The RGB, component or HDTV signal input from
the INPUT A connectors
B: The RGB, component, HDTV, S video or video
signal input from the INPUT B connectors
C: This key does not function with this projector.
3 VIDEO MEMORY keys
Select the preset or adjusted data by pressing keys 1 to
10. To reset to the data of the input signal, press OFF
key.
4 Lithium battery holder
Install the supplied lithium battery.
1
u 1
2
B C
2 3
5 6
3
8 9
OFF
Lithium battery installation –– RM-PJD50
1
Pull out the lithium battery holder from the remote
control.
2
Install the lithium battery.
+ side facing upward
3
Put the lithium battery holder back into the remote
control.
Notes on the lithium battery
• Keep the lithium battery out of the reach of children.
• Should the battery be swallowed, immediately
consult a doctor.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer's instructions.
13
(GB)