Sony VPH-D50HTM Operating Instructions Manual page 17

Battery installation –– RM-PJ1001
1
Push to open the lid.
2
Install the three size AA (R6) batteries (supplied)
with the correct polarity.
Be sure to install
the battery from
the ' side.
3
Replace the lid.
Notes on batteries
• Be careful that the battery orientation is correct when
inserting batteries.
• Do not mix old battery with new one, or different
types of batteries.
• If you do not intend to use the remote control for a
long time, remove the batteries to avoid damage from
battery leakage. If a battery has leaked, remove the
batteries, wipe the battery compartment dry and
replace the batteries with new ones.
Notes on wireless remote control operation
• Be sure that there is nothing to obstruct the infrared
beam between the remote control and the projector.
• The operation range is limited. The shorter the
distance between the remote control and the
projector, the wider the angle within which the
remote control can control the projector.
• The remote control detectors on the projector do not
operate when the remote control is being used as a
wired remote control. If you wish to use the remote
control as a wireless remote control, be sure to
remove the connecting cable from both the remote
control and the projector.
Connecting the remote control to the
projector
Rear of the projector
Remote control cable (supplied)
CONTROL S IN
IN OUT
PLUG IN POWER
CONTROL S
CONTROL
S OUT
17
(GB)