Panel (U1); Tilt Angle Adjustment - Sony SRX-T420 Installation Manual

1-1-8. Panel (U1)

1. Remove the panel (U7) block assembly. (Refer to Section 1-1-2.)
2. Remove the panel (U2) block assembly. (Refer to Section 1-1-3.)
3. Remove the panel (U6). (Refer to Section 1-1-5.)
4. Remove the panel (U1B). (Refer to Section 1-1-7.)
5. Remove the eight screws, then remove the panel (U1).
6. To install, reverse the removal procedure.

1-2. Tilt Angle Adjustment

n
For further adjustment, "2-6. Field Angle Adjustment" is required.
In the case of tilt angle under 5 degrees:
Adjust the tilt angle using the adjuster in the lower portion of this unit.
1. Loosen the nut.
2. Adjust the tilt angle by rotating the adjuster in the
lower portion of this unit.
3. Secure the adjuster by tightening the nut to the adjuster
pipe side.
SRX-T420
Screws
Screws
Panel (U1)
Screws
Fig. 1-1-8
Fig. 1-2a
Screws
Adjuster pipe
Nut
Adjuster
1-5